- Guides
Buyer guides
Short, practical answers to the questions resellers and their customers ask most.
Bent dispensing needles: 45-degree, all-metal and elbow tips
Use a bent needle when the joint is recessed, behind a lip or along an inside edge, so the syringe or valve can stay upright. Choose a 45-degree plastic-hub needle for general adhesives in fine gauges, an all-metal bent needle for solvents and heavier gauges, and a plastic elbow tip for thick materials on surfaces that must not be scratched.
Read the guideDispensing needles for cyanoacrylate and UV-curing adhesives
Cyanoacrylates and anaerobics tend to cure inside a bare stainless steel cannula, so use a PTFE-lined needle, a one-piece polypropylene needle or a flexible polypropylene tip. UV-curing adhesives can start to cure inside a translucent hub, so use a needle with an opaque black hub. Choose the gauge by bore, then test on your own adhesive and cycle time.
Read the guideDual cartridges, mix ratios and dispensing guns
A dual cartridge ratio such as 2:1 means two volumes of component A leave the cartridge for every one volume of component B, and the chamber sizes fix that ratio. Choose a gun built for that exact ratio and cartridge format, manual for intermittent work or pneumatic for long runs, and a mixer that fits the cartridge outlet.
Read the guideFinding an equivalent dispensing tip by brand part number
Search the customer's current part number in our cross-reference. A direct equivalent matches the recorded gauge, length and fitting; same gauge and length means check the fitting; nearest equivalent means the closest part in our range, with differences to check. If a part number is not listed, send it with the gauge, length and hub, and we map it for you.
Read the guideHow to choose a dispensing needle gauge
Higher gauge numbers mean finer bores: pick a finer gauge for thin fluids and fine dots, and a wider bore or a tapered tip for thick pastes. Choose by the actual ID and OD on the spec table, keep the needle as short as the job allows, and never identify gauge by hub color.
Read the guideHow to choose a static mixer
Match the mixer to the cartridge inlet first (bayonet, MB series or round mouth), then choose the shortest element count that gives a uniform, fully cured test bead. The cartridge sets the ratio, but 4:1 and 10:1 materials need a mixer built for high ratios.
Read the guideLuer lock vs Luer slip dispensing needles
A Luer lock needle screws into a threaded collar on the syringe or valve outlet and cannot pull off without being unscrewed. A Luer slip needle sits on the same taper held only by friction, so for any pressure-fed dispensing a locking or threaded connection is the safer choice.
Read the guide